Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2010 honda fuse panel
Viewing all articles
Browse latest Browse all 10

1999-2000 Honda Passport Stereo/Radio Installation Procedures

0
0

Honda makes quite a lot of cars, vans, SUVs and minivans. All the automobiles in the Honda family include the factory choice of selecting amongst several stereo systems. For Honda house owners who prefer a system from an aftermarket provider, nonetheless, with proper element adaptation, no earlier automotive audio experience is necessary to install a new stereo. The directions on this article detail the set up process for a 1999-2000 Honda Passport. The Passport shares a chassis with the Isuzu Rodeo, and both vehicles have stereo dock design options just like the Honda Accord, Civic and Odyssey.

1999-2000 Honda Passport Stereo/Radio Installation Instructions

1. Raise the hood of the Honda Passport by pulling the hood-launch deal with below the motive force’s side dash panel.
2. Disconnect the grounding cable from the negative battery terminal with the ten mm wrench. Set the cable aside till after the radio installation.
3. Pull the ashtray from the dashboard and take away the steel ashtray bracket in the opening. Remove the screw in the back of the ashtray slot with the Phillips screwdriver.
4. Pry the center sprint panel from the dashboard with a trim panel elimination software or flat screwdriver. Pull the panel from the sprint and disconnect the cigarette lighter wiring from the back of the panel.
5. Take away the four screws across the perimeter of the stereo mounting bracket with a Phillips screwdriver.
6. Pull your entire bracket from the stereo dock. Unplug the stereo wiring from the again of the factory radio. Disconnect the antenna cable from the back panel of the radio.
7. Take away the two screws on both sides of the bracket to free the factory radio.
8. Place the brand new stereo in the stereo mounting bracket. Screw in the two screws on both side of the bracket to secure the brand new stereo.
9. Join the stereo wiring to a wiring harness adapter. The stereo wiring is grouped together in plastic binders that plug into the leads of the wiring harness. Plug the wiring harness leads into the back panel of the aftermarket stereo. Plug the antenna cable into the antenna outlet on the proper facet of the aftermarket stereo’s rear panel.
10. Return the stereo mounting bracket, with new stereo put in, into the stereo mounting dock. Substitute the screws around the perimeter with the screwdriver.
11. Plug in the cigarette lighter wiring into the outlets on the again of the center dash panel. Align the panel across the stereo meeting and press it firmly into place against the dashboard. The panel will snap into place.
12. Screw within the screw at the back of the vacant ashtray opening. Change the ashtray bracket and the ashtray itself. Return to the battery.
13. Place the grounding cable clamp across the negative lead publish and tighten the clamp to the post with the wrench. Close the hood of the Honda Passport.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images