Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2010 honda fuse panel
Viewing all articles
Browse latest Browse all 10

Honda CRV XM Radio Installation – Page 2

0
0

Installing the XM Radio Unit

XM Radio Unit17. Install the XM Radio bracket A and bracket B to the XM Radio Unit utilizing the 4 5 x eight mm screws and 4 washers provided.
18. Loosely attach one 6 x 12 mm washer-bolt to the top of the XM radio bracket A and bracket B.
19. Route the XM radio meeting in back of the gasoline lid opener cable and the drain tub, and place the XM radio assembly into the body panel. Set the two 6 x 12 mm washer-bolts into the elongated holes in the body panel. Tighten the 2 6 x 12 mm washer-bolts.
20. Find the car 14-pin connector taped the body panel, and remove the cushion tape to the free connector. Plug the automobile 14-pin connector into the XM Radio Unit.

XM Radio Antenna Installation

21. Insert the XM radio antenna connector by the outlet of the roof panel, and route the XM radio antenna connector out the again of the roofliner. Position XM radio antenna onto the roof panel. Watch out not to bend the headliner. NOTE: If the stud-bolt from the XM radio antenna interferes with the interior panel between the roof panel and headliner, push the inner panel forward to install the XM radio. If the stud-bolt interferes with the internal panel though the panel is pushed ahead, slit the internal panel, and install the XM radio antenna.
22. Get the nut removed in step 14, and set up the nut onto the XM radio antenna. Torque the nut to 8 N·m (11Ib-ft). Watch out to not pinch the XM radio antenna cable.
23. Route the XM radio antenna cable below the headliner as shown. Be careful not to bend the headliner.
24. Using scissors, cut one cushion tape in half.
25. Using a isopropyl alcohol on a shop towel, clean the realm where the cushion tapes will attach. Safe the XM radio antenna cable to the roof panel with two half items of cushion tape, and two full cushion tapes.
26. Proceed to route the XM radio antenna cable down the body panel to the XM Radio Unit.
27. Using scissors, cut one cushion tape in half.
28. Using a isopropyl alcohol on a store towel, clear the area where the cushion tapes will attach. Secure the XM radio antenna cable to the physique panel and the harness with two half pieces of cushion tape, three full cushion tapes, and one wire tie.

Page 1 | Page 2 | Page 3


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images