2000 Honda CRV Stereo/Radio Replacement

The CR-V is Honda’s small SUV, designed to take four individuals comfortably round each on- and off-road. Like most other vehicles, it comes with a typical stereo. But it will probably break, or possibly it lacks options you need, by which case you can replace it fairly simply in your own. In this case, the venture vehicle is a 2000 Honda CR-V.

2000 Honda CRV Stereo/Radio Replacement Procedures

1. Locate the interior knee panel on the driver’s aspect, slightly below the steering wheel. Take away the two Phillips-head screws, utilizing the Phillips-head screwdriver, then pull the panel away from the sprint, utilizing your arms to launch the clips.
2. Move to the passenger side of the automobile and open the glove box. Maintain the sides of the glove box and push the sides in to permit the box to drop down. Remove the two Phillips-head screws on the left side of the glove box opening, using the Phillips-head screwdriver.
3. Locate the small interior pocket at the backside of the center of the dash. Use the interior clip removing software to pop off the clips on either side of the panel, after which remove it from the dash.
4. Seize the plastic panel under the stereo and slowly pull it away from the dashboard. The panel is held to the sprint by the wiring for the cigarette lighter, so disconnect it utilizing your hands, and then pull the panel utterly away from the dash.
5. Locate the two Phillips-head screws and two eight-millimeter bolts on either aspect of the stereo, which were hidden by the panel you removed in Step 4. Remove them, using a Phillips-head screwdriver and the 1/4-inch ratchet and socket, and then pull the stereo panel away from the dashboard. Unplug the wiring harness and antenna lead from the back, using your hands.
6. Unbolt the stereo from the stereo panel, using the 1/four-inch ratchet and socket. Slide the manufacturing unit stereo out of the stereo panel, then set up the alternative stereo as a substitute using the same hardware and tools. Plug the wiring harness and antenna lead into the again of the stereo, and then place the assembly again in the dash.
7. Reassemble the dashboard within the reverse order of disassembly.