Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2010 honda fuse panel
Viewing all articles
Browse latest Browse all 10

2010 Honda CR-V Fog Lights Installation – Page 4

$
0
0

Honda CR-V fog lights Installation – Continued…

fog light42. Flip the steering wheel 90° counterclockwise, and unplug the vehicle connector from the sunshine/flip sign switch.
43. Remove the two self-tapping screws from the light/turn sign switch. While pushing the retaining tab, slide the light/turn sign swap, and remove it from the steering column. Whereas eradicating, do not hold the light/turn sign switch by the lever.
44. Install the new light/turn sign change on the steering column with two self-tapping screws. While installing do not hold the light swap by the lever.
45. Plug the vehicle connector into the new light/turn sign switch.
46. If the 20A fuse is already installed within the fuse box, go to step 47, otherwise set up the 20A fuse to the fuse box.
47. Check that every one wire harnesses are routed correctly and all connectors are plugged in.
48. Reinstall all eliminated parts. Don’t reinstall the bumper clip and bolts that fasten the bumper at this time. Verify that every one clips and fasteners are installed securely.
49. Reconnect the negative cable to the battery.
50. Reset the clock, and reset the XM radio presets (if outfitted).
fog light Aiming Adjustment
51. Modify the fog lights : •Pull down the inner fender and beneath cover. •Alter the aiming based on native laws and regulations. •To adjust, flip the aiming adjustment knob in or out until the correct aiming is obtained.
52. Reinstall the bumper clips and bolts.
BULB REPLACEMENT
1. Take away one bolt and one clip, and pull down the beneath cowl and interior fender.
2. Unplug the connector from the fog light.
3. Remove the bulb.
4. Set up the brand new bulb and socket to the fog lights. Use only a Guine Honda halogen gentle bulb of specified wattage. Rating: 12V 55W H11 Halogen Gentle Bulb P/N 33165-S5A-003.
5. Reinstall the removed components within the reverse order of removal. •Verify that the wire harnesses will not be pinched. •Be sure you tighten the clip and bolts securely.
6. Check the operation of the fog light; modify the aiming if necessary.

Page 1 | Page 2 | Page 3 | Page 4


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images